Inktronic Conductive Foil

InkTronic™ Conductive Foil

You can actually print electronic circuitry with the Gerber Edge!

On-demand printing of circuitry is now possible with InkTronic™ Conductive and dielectric foil. This foil allows companies who have a Gerber Edge® printer to print cost-effective on-demand prototypes and short runs of printed circuits that are placed directly onto flexible materials such as PolyTronic™ polyester, Armalex™ and High-Bond polyester. InkTronic is a resin foil pigmented with conductive aluminum particles.

InkTronic conductive foil gives you consistent thickness and sharp lines and traces. InkTronic is ready to be used immediately after printing without any post-process sintering.

Dielectric foil is also available.

 

PHYSICAL PROPERTIES:

Volume Resistivity: 3.00 µΩ·cm

Power Capacity: 2.50W

Maximum Current Density: 410 A/mm

Bend Test (ASTM F2750-09), Percent increase in resistivity after 100 bends: Compression 0.65%

Bend Test (ASTM F2750-09), Percent increase in resistivity after 100 bends: Extension 0.50%

Cross – Hatch Adhesion Test (ASTM F1842-09): 5

Environmental Aging Test: (ASTM F1996-06) 38°C, 95%RH, 10 days: Pass

Drying Time: Immediate

Sintering: Not Required

Thickness: To 0.3 µ