Locate Id: 1884

Metallograph Conductive Foil

Metallograph® Conductive Foil

You can print electronic circuitry with the Gerber Edge!

On-demand printing of circuitry is now possible with Metallograph® Conductive and dielectric foil. This foil allows anyone who has a Gerber Edge® printer to print cost-effective on-demand prototypes and short runs of printed circuits that are placed directly onto flexible materials such as Armalex™ and High-Bond polyester. Metallograph is a resin foil pigmented with conductive aluminum particles.

Metallograph conductive foil gives you consistent thickness and sharp lines and traces. It is ready to be used immediately after printing without any post-process sintering.

Dielectric foil is also available.

APPLICATIONS:

- UHF RFID Antenna
- Blister packs with dosing records
- Low power printed circuits
- Environmental sensors and indicators
- Chipless RFID
- Printed electroluminescent displays

 

PHYSICAL PROPERTIES:

Volume Resistivity: 3.00 µΩ·cm

Power Capacity: 2.50W

Maximum Current Density: 410 A/mm

Bend Test (ASTM F2750-09), Percent increase in resistivity after 100 bends: Compression 0.65%

Bend Test (ASTM F2750-09), Percent increase in resistivity after 100 bends: Extension 0.50%

Cross – Hatch Adhesion Test (ASTM F1842-09): 5

Environmental Aging Test: (ASTM F1996-06) 38°C, 95%RH, 10 days: Pass

Drying Time: Immediate

Sintering: Not Required

Thickness: To 0.3 µ

  1. Metallograph 3 micro ohm - 12 in x 50 Meter

    IT1250FX3OHM
    $379.68
  2. Metallograph 3 micro ohm - 12 in x 92 Meter

    IT1292FX3OHM
    $686.18
  3. Metallograph Green Die Electric - 12 in x 50 Meter

    IT1250FXDE
    $220.10
  4. Metallograph Green Die Electric - 12 in x 92 Meter

    IT1292FXDE
    $388.40